|Traced part |
Tracing with the marking gauge is a means of dimensional check that has become obsolete and thus is no longer used . New techniques of 3D dimensional statements are a much favoured replacement for this method.
- Dimensional control is carried out in the traditional way or with a FARO arm.
- Three-dimensional control is carried out by the BRAUN & SHARP measurement centre.
CONTIFONTE has a hinged "FARO" jib which allows three-dimensional control of parts.
- It is used to measure all characteristics of untreated and machined parts (geometry, perpendicularity, angles...)
- A control report is published and forwarded upon request.